|
|
Angulo, C., Gaiser, T., Rötter, R. P., Børgesen, C. D., Hlavinka, P., Trnka, M., et al. (2014). ‘Fingerprints’ of four crop models as affected by soil input data aggregation. European Journal of Agronomy, 61, 35–48.
Abstract: • Systematic analysis of the influence of spatial soil data resolution on simulated regional yields and total growing season evapotranspiration. • The responses of four crop models of different complexity are compared. • Differences between models are larger than the effect of the chosen spatial soil data resolution. • Low influence of soil data resolution due to: high precipitation amount, methods for calculating water retention and method of data aggregation. The spatial variability of soil properties is an important driver of yield variability at both field and regional scale. Thus, when using crop growth simulation models, the choice of spatial resolution of soil input data might be key in order to accurately reproduce observed yield variability. In this study we used four crop models (SIMPLACE<LINTUL-SLIM>, DSSAT-CSM, EPIC and DAISY) differing in the detail of modeling above-ground biomass and yield as well as of modeling soil water dynamics, water uptake and drought effects on plants to simulate winter wheat in two (agro-climatologically and geo-morphologically) contrasting regions of the federal state of North-Rhine-Westphalia (Germany) for the period from 1995 to 2008. Three spatial resolutions of soil input data were taken into consideration, corresponding to the following map scales: 1:50 000, 1:300 000 and 1:1 000 000. The four crop models were run for water-limited production conditions and model results were evaluated in the form of frequency distributions, depicted by bean-plots. In both regions, soil data aggregation had very small influence on the shape and range of frequency distributions of simulated yield and simulated total growing season evapotranspiration for all models. Further analysis revealed that the small influence of spatial resolution of soil input data might be related to: (a) the high precipitation amount in the region which partly masked differences in soil characteristics for water holding capacity, (b) the loss of variability in hydraulic soil properties due to the methods applied to calculate water retention properties of the used soil profiles, and (c) the method of soil data aggregation. No characteristic “fingerprint” between sites, years and resolutions could be found for any of the models. Our results support earlier recommendation to evaluate model results on the basis of frequency distributions since these offer quick and better insight into the distribution of simulation results as compared to summary statistics only. Finally, our results support conclusions from other studies about the usefulness of considering a multi-model approach to quantify the uncertainty in simulated yields introduced by the crop growth simulation approach when exploring the effects of scaling for regional yield impact assessments.
|
|
|
|
Schils, R., Olesen, J. E., Kersebaum, K. - C., Rijk, B., Oberforster, M., Kalyada, V., et al. (2018). Cereal yield gaps across Europe. Europ. J. Agron., 101, 109–120.
Abstract: Europe accounts for around 20% of the global cereal production and is a net exporter of ca. 15% of that production. Increasing global demand for cereals justifies questions as to where and by how much Europe’s production can be increased to meet future global market demands, and how much additional nitrogen (N) crops would require. The latter is important as environmental concern and legislation are equally important as production aims in Europe. Here, we used a country-by-country, bottom-up approach to establish statistical estimates of actual grain yield, and compare these to modelled estimates of potential yields for either irrigated or rainfed conditions. In this way, we identified the yield gaps and the opportunities for increased cereal production for wheat, barley and maize, which represent 90% of the cereals grown in Europe. The combined mean annual yield gap of wheat, barley, maize was 239 Mt, or 42% of the yield potential. The national yield gaps ranged between 10 and 70%, with small gaps in many north-western European countries, and large gaps in eastern and south-western Europe. Yield gaps for rainfed and irrigated maize were consistently lower than those of wheat and barley. If the yield gaps of maize, wheat and barley would be reduced from 42% to 20% of potential yields, this would increase annual cereal production by 128 Mt (39%). Potential for higher cereal production exists predominantly in Eastern Europe, and half of Europe’s potential increase is located in Ukraine, Romania and Poland. Unlocking the identified potential for production growth requires a substantial increase of the crop N uptake of 4.8 Mt. Across Europe, the average N uptake gaps, to achieve 80% of the yield potential, were 87, 77 and 43 kg N ha(-1) for wheat, barley and maize, respectively. Emphasis on increasing the N use efficiency is necessary to minimize the need for additional N inputs. Whether yield gap reduction is desirable and feasible is a matter of balancing Europe’s role in global food security, farm economic objectives and environmental targets.
|
|
|
|
Trnka, M. (2013). Guidelines on extending on-going experiments with additional measurements to support crop modelling – Field experimental protocol (Vol. 2).
Abstract: The input data necessary for crop model simulations and data for their calibration/validation (and thus requirements for observations and measurements in suitable experiments) are listed. A list of possible seasonal observations/measurements that could be carried out in existing experiments to increase their potential for crop modelling studies is also provided. The general methodology suitable to be used is outlined, but in all cases the selected method depends strongly on the experimental set-up and facilities/instruments at the disposal of the experimentalists. Such methodologies needs to be documented and preferably benchmarked against standard methods. No Label
|
|
|
|
Pohanková, E., Hlavinka, P., Kersebaum, K. C., Dubrovský, M., Fischer, M., Balek, J., et al. (2015). Pilot study: Field crop rotations modeling under present and future conditions in the Czech Republic using HERMES model (Vol. 5).
Abstract: The aim of this study is to compare the water and organic material balance, yields and other aspects estimated within crop rotations by the Hermes crop model for present and future climatic conditions in the Czech Republic. Moreover, this is a pilot study for the complex and continuous crop rotations modeling (using both single crop models and ensembles) in connection with transient climate change scenarios. For this purpose, three locations representing important agricultural regions of the Czech Republic (with different climatic conditions) were selected. The crop rotation (including spring barley, silage maize, winter wheat, winter rape, and winter wheat in the listed order) was simulated from 1981-2080. The period 1981-2010 was covered by measured meteorological data, and the period 2011-2080 was represented by a transient synthetic weather series from the weather generator M&Rfi. The generated data was based on five circulation models representing an ensemble of 18 CMIP3 global circulation models to preserve to a large degree the uncertainty of the original ensemble. Two types of crop management were compared, and the influences of soil quality, increasing atmospheric CO2 and magnitude of adaptation measure (in the form of sowing date changes) were also considered. According to the results, if a “dry” scenario (such as GFCM21) would occur, then all the C3 crops produced in drier regions would be devastated in a significant number of seasons; for example, by the 2070s, up to 19.5%, 21.5% and 47.0% of seasons with winter rape, spring barley and winter wheat, respectively, would have a yield level below 50% of the present yield. Negative impacts are likely even on premium-quality soils regardless of the use of a flexible sowing date and accounting for increasing CO2 concentrations. Moreover, in some cases, the use of catch crops can have negative impacts, exacerbating the soil water deficit for the subsequent crops. This study (submitted to Climate Research journal) will be used as a pilot for subsequent activities. In this area, following calculations (the same set of stations and updated climate scenarios) using growth models ensemble (currently includes 12 modeling approaches) started to estimate uncertainty aspects. Consequently, the analysis within wider range of conditions (across continents) and farming methods will be conducted. No Label
|
|
|
|
Sharif, B., Mankowski, D., Kersebaum, K. C., Trnka, M., Schelde, K., & Olsesen, J. E. (2015). Empirical analysis on crop-weather relationships (Vol. 6).
Abstract: There have been several studies, where process-based crop models are developed, used and compared in order to project crop production and corresponding model uncertainties under climate change. Despite many advances in this field, there are some correlations between climate variables and crop growth, such as pest and diseases, that is often absent in process-based models. Such relationships can be simulated using empirical models. In this study, several statistical techniques were applied on winter oilseed rape data collected in some European countries. The empirical models were then used to predict yield of winter oilseed rape in the field experiments during more than 20 years, up to 2013. Results suggest that newly developed regression techniques such as shrinkage methods work well both in yield projections and finding the influential climatic variables. Many of regression techniques agree in terms of yield prediction; however, choice of significant climate variables is rather sensitive to the choice of regression technique. No Label
|
|
