Abstract: The aim of this study is to compare the water and organic material balance, yields and other aspects estimated within crop rotations by the Hermes crop model for present and future climatic conditions in the Czech Republic. Moreover, this is a pilot study for the complex and continuous crop rotations modeling (using both single crop models and ensembles) in connection with transient climate change scenarios. For this purpose, three locations representing important agricultural regions of the Czech Republic (with different climatic conditions) were selected. The crop rotation (including spring barley, silage maize, winter wheat, winter rape, and winter wheat in the listed order) was simulated from 1981-2080. The period 1981-2010 was covered by measured meteorological data, and the period 2011-2080 was represented by a transient synthetic weather series from the weather generator M&Rfi. The generated data was based on five circulation models representing an ensemble of 18 CMIP3 global circulation models to preserve to a large degree the uncertainty of the original ensemble. Two types of crop management were compared, and the influences of soil quality, increasing atmospheric CO2 and magnitude of adaptation measure (in the form of sowing date changes) were also considered. According to the results, if a “dry” scenario (such as GFCM21) would occur, then all the C3 crops produced in drier regions would be devastated in a significant number of seasons; for example, by the 2070s, up to 19.5%, 21.5% and 47.0% of seasons with winter rape, spring barley and winter wheat, respectively, would have a yield level below 50% of the present yield. Negative impacts are likely even on premium-quality soils regardless of the use of a flexible sowing date and accounting for increasing CO2 concentrations. Moreover, in some cases, the use of catch crops can have negative impacts, exacerbating the soil water deficit for the subsequent crops. This study (submitted to Climate Research journal) will be used as a pilot for subsequent activities. In this area, following calculations (the same set of stations and updated climate scenarios) using growth models ensemble (currently includes 12 modeling approaches) started to estimate uncertainty aspects. Consequently, the analysis within wider range of conditions (across continents) and farming methods will be conducted. No Label

Abstract: Crop growth simulation models can differ greatly in their treatment of key processes and hence in their response to environmental conditions. Here, we used an ensemble of 26 process-based wheat models applied at sites across a European transect to compare their sensitivity to changes in temperature (−2 to +9°C) and precipitation (−50 to +50%). Model results were analysed by plotting them as impact response surfaces (IRSs), classifying the IRS patterns of individual model simulations, describing these classes and analysing factors that may explain the major differences in model responses.   The model ensemble was used to simulate yields of winter and spring wheat at sites in Finland, Germany and Spain. Results were plotted as IRSs that show changes in yields relative to the baseline with respect to temperature and precipitation. IRSs of 30-year means and selected extreme years were classified using two approaches describing their pattern.   The expert diagnostic approach (EDA) combines two aspects of IRS patterns: location of the maximum yield (nine classes, Figure 1) and strength of the yield response with respect to climate (four classes), resulting in a total of 36 combined classes defined using criteria pre-specified by experts. The statistical diagnostic approach (SDA) groups IRSs by comparing their pattern and magnitude, without attempting to interpret these features. It applies a hierarchical clustering method, grouping response patterns using a distance metric that combines the spatial correlation and Euclidian distance between IRS pairs. The two approaches were used to investigate whether different patterns of yield response could be related to different properties of the crop models, specifically their genealogy, calibration and process description.   Although no single model property across a large model ensemble was found to explain the integrated yield response to temperature and precipitation perturbations, the application of the EDA and SDA approaches revealed their capability to distinguish: (i) stronger yield responses to precipitation for winter wheat than spring wheat; (ii) differing strengths of response to climate changes for years with anomalous weather conditions compared to period-average conditions; (iii) the influence of site conditions on yield patterns; (iv) similarities in IRS patterns among models with related genealogy; (v) similarities in IRS patterns for models with simpler process descriptions of root growth and water uptake compared to those with more complex descriptions; and (vi) a closer correspondence of IRS patterns in models using partitioning schemes to represent yield formation than in those using a harvest index.   Such results can inform future crop modelling studies that seek to exploit the diversity of multi-model ensembles, by distinguishing ensemble members that span a wide range of responses as well as those that display implausible behaviour or strong mutual similarities.   The full manuscript of this study is currently under revision (Fronzek et al. 2017).