Abstract: Climate and soil data at coarse resolution are often used as input for crop models in order to simulate crop yields at larger scales, e.g. at regional or national level, potentially leading to biased yield estimates. While the response to data resolution differs between crop models, it is unknown how the spatial aggregation of different types of input data interacts and contributes to this so-called aggregation effect. An ensemble of crop models was run with soil and climate input data at different spatial resolutions from 1 to 100 km for the state of North Rhine-Westphalia, Germany. For this purpose, climate time series were averaged spatially and soil data was aggregated by selecting the dominant soil type with a representative soil profile based on a soil map at the scale of 1:50,000. Yields of winter wheat and silage maize were simulated under potential, water-limited and water-nitrogen-limited production conditions. Crop yields from soil and climate aggregation were evaluated separately.Mean of crop yields of the region and over the simulation period were reasonably reproduced by most models regardless of input data resolution, either using aggregated soil or climate as input. However, larger aggregation effects were observed at higher temporal resolution (e.g. annual yields). Models revealed similar spatial patterns in yield. Being distinct for soil and climate aggregation, these patterns indicate a larger impact of soil aggregation on the spatial distribution of simulated crop yield for this region. Additionally, models differed considerably in their susceptibility to input data aggregation. The results reveal the importance of model ensemble assessments and the relevance of data aggregation when short simulation periods are considered. No Label

Abstract: Crop growth simulation models can differ greatly in their treatment of key processes and hence in their response to environmental conditions. Here, we used an ensemble of 26 process-based wheat models applied at sites across a European transect to compare their sensitivity to changes in temperature (−2 to +9°C) and precipitation (−50 to +50%). Model results were analysed by plotting them as impact response surfaces (IRSs), classifying the IRS patterns of individual model simulations, describing these classes and analysing factors that may explain the major differences in model responses.   The model ensemble was used to simulate yields of winter and spring wheat at sites in Finland, Germany and Spain. Results were plotted as IRSs that show changes in yields relative to the baseline with respect to temperature and precipitation. IRSs of 30-year means and selected extreme years were classified using two approaches describing their pattern.   The expert diagnostic approach (EDA) combines two aspects of IRS patterns: location of the maximum yield (nine classes, Figure 1) and strength of the yield response with respect to climate (four classes), resulting in a total of 36 combined classes defined using criteria pre-specified by experts. The statistical diagnostic approach (SDA) groups IRSs by comparing their pattern and magnitude, without attempting to interpret these features. It applies a hierarchical clustering method, grouping response patterns using a distance metric that combines the spatial correlation and Euclidian distance between IRS pairs. The two approaches were used to investigate whether different patterns of yield response could be related to different properties of the crop models, specifically their genealogy, calibration and process description.   Although no single model property across a large model ensemble was found to explain the integrated yield response to temperature and precipitation perturbations, the application of the EDA and SDA approaches revealed their capability to distinguish: (i) stronger yield responses to precipitation for winter wheat than spring wheat; (ii) differing strengths of response to climate changes for years with anomalous weather conditions compared to period-average conditions; (iii) the influence of site conditions on yield patterns; (iv) similarities in IRS patterns among models with related genealogy; (v) similarities in IRS patterns for models with simpler process descriptions of root growth and water uptake compared to those with more complex descriptions; and (vi) a closer correspondence of IRS patterns in models using partitioning schemes to represent yield formation than in those using a harvest index.   Such results can inform future crop modelling studies that seek to exploit the diversity of multi-model ensembles, by distinguishing ensemble members that span a wide range of responses as well as those that display implausible behaviour or strong mutual similarities.   The full manuscript of this study is currently under revision (Fronzek et al. 2017).