Abstract: Impact response surfaces (IRSs) of spring and winter wheat yields were constructed from a 26-member ensemble of process-based crop simulation models for sites in Finland, Germany and Spain across a latitudinal transect in Europe. The sensitivity of modelled yield to systematic increments of changes in temperature (-2 to +9°C) and precipitation (-50 to +50%) was tested by modifying values of 1981–2010 baseline weather.In spite of large differences in simulated yield responses to both baseline and changed climate between models, sites, crops and years, several common messages emerged. Ensemble average yields decline with higher temperatures (3–7% per 1°C) and decreased precipitation  (3–9% per 10% decrease), but benefit from increased precipitation (0-8% per 10% increase). Yields are more sensitive to temperature than precipitation changes at the Finnish site while sensitivities are mixed at the German and Spanish sites. Precipitation effects diminish under higher temperature changes. Inter-model variability is highest for baseline climate at the Spanish site, but relatively insensitive to changed climate. Modelled responses diverge most at the Finnish and German sites for winter wheat under temperature change. The IRS pattern of yield reliability tracks average yield levels. Inter-annual yield variability is more sensitive to precipitation than temperature, except at the Spanish site for spring wheat.Optimal temperatures for present-day cultivars are close to the baseline under Finnish conditions but below the baseline at the German and Spanish sites. This suggests that adoption of later maturing cultivars with higher temperature requirements might already be advantageous, and increasingly so under future warming. No Label

Abstract: Data quality is a key factor in determining the quality of model estimates and hence a models’ overall utility. Good models run with poor quality explanatory variables and parameters will produce meaningless estimates. Many models are now well developed and have been shown to perform well where and when good quality data is available. Hence a major limitation now to further use of models in new locations and applications is likely to be the availability of good quality data. Improvements in the quality of data may be seen as the starting point of further model improvement, in that better data itself will lead to more accurate model estimates (i.e. through better calibration), and it will facilitate reduction of model residual error by enabling refinements to model equations. This report sets out why data quality is important as well as the basis for additional investment in improving data quality. No Label

Abstract: The purpose of this report is to propose a general procedure for sensitivity analysis when used to evaluate system sensitivity to climate change, including uncertainty information. While sensitivity analysis has been largely used to evaluate how uncertainties in inputs or parameters propagate through the model and manifest themselves in uncertainties in model outputs, there is much less experience with sensitivity analysis as a tool for studying how sensitive a system is to changes in inputs. This report should help make clear the differences between these two uses of sensitivity analysis, and provide guidance as to the procedure for using sensitivity analysis for evaluating system sensitivity to climate change. No Label