| Home | << 1 2 3 4 >> |
|
Sándor, R., Barcza, Z., Hidy, D., Lellei-Kovács, E., Ma, S., & Bellocchi, G. (2016). Modelling of grassland fluxes in Europe: evaluation of two biogeochemical models. Agric. Ecosyst. Environ., 215, 1–19.
Abstract: Two independently developed simulation models – the grassland-specific PaSim and the biome-generic Biome-BGC MuSo (BBGC MuSo) – linking climate, soil, vegetation and management to ecosystem biogeochemical cycles were compared in a simulation of carbon (C) and water fluxes. The results were assessed against eddy-covariance flux data from five observational grassland sites representing a range of conditions in Europe: Grillenburg in Germany, Laqueuille in France with both extensive and intensive management, Monte Bondone in Italy and Oensingen in Switzerland. Model comparison (after calibration) gave substantial agreement, the performances being marginal to acceptable for weekly-aggregated gross primary production and ecosystem respiration (R-2 similar to 0.66 – 0.91), weekly evapotranspiration (R-2 similar to 0.78 – 0.94), soil water content in the topsoil (R-2 similar to 0.1 -0.7) and soil temperature (R-2 similar to 0.88 – 0.96). The bias was limited to the range -13 to 9 g C m(-2) week(-1) for C fluxes (-11 to 8 g C m(-2) week(-1) in case of BBGC MuSo, and -13 to 9 g C m(-2) week(-1) in case of PaSim) and -4 to 6 mm week for water fluxes (with BBGC MuSo providing somewhat higher estimates than PaSim), but some higher relative root mean square errors indicate low accuracy for prediction, especially for net ecosystem exchange The sensitivity of simulated outputs to changes in atmospheric carbon dioxide concentration ([CO2]), temperature and precipitation indicate, with certain agreement between the two models, that C outcomes are dominated by [CO2] and temperature gradients, and are less due to precipitation. ET rates decrease with increasing [CO2] in PaSim (consistent with experimental knowledge), while lack of appropriate stomatal response could be a limit in BBGC MuSo responsiveness. Results of the study indicate that some of the errors might be related to the improper representation of soil water content and soil temperature. Improvement is needed in the model representations of soil processes (especially soil water balance) that strongly influence the biogeochemical cycles of managed and unmanaged grasslands. (C) 2015 Elsevier B.V. All rights reserved.
|
|
Bellocchi, G., Ma, S., Köchy, M., & Braunmiller, K. (2013). Identified grassland-livestock production systems and related models (Vol. 2).
Abstract: This report describes grassland-livestock production systems, as selected for model-basedstudies. A list of grassland models was identified for evaluation against such datasets(WP2) and application at reference farm (WP3) and regions (WP4) across Europe and peri-European countries. No Label
|
|
Ma, S., Ben, T., H., Lellei-Kovács, E., Barcza, Z., Hidy, D., & Bellocchi, G. (2014). Grassland model intercomparison of the knowledge hub MACSUR: illustrative results from the models PaSim and Biome-BGC MuSo..
|
|
Tomozeiu, R., Pasqui, M., & Quaresima, S. (2017). Future changes of air temperature over Italian agricultural areas: a statistical downscaling technique applied to 2021–2050 and 2071–2100 periods. Meteorology and Atmospheric Physics, in press.
Abstract: Climate change scenarios of seasonal minimum and maximum temperature over different Italian agricultural areas, during the periods 2021–2050 and 2071–2100 against 1961–1990, are assessed. The areas are those selected in the framework of the Agroscenari project and are represented by: Padano–Veneta plain, Marche, Beneventano, Destra Sele, Oristano, Puglia and Sicilia, all areas of prominent agricultural vocation with excellence productions. A statistical downscaling technique applied to ENSEMBLES global climate simulations, emission scenario A1B, is used to achieve this objective. The statistical scheme consists of a multivariate regression based on Canonical Correlation Analysis. The scheme is constructed using large-scale fields derived from ECMWF reanalysis and seasonal mean minimum, maximum temperature derived from national observed daily gridded data that cover 1959–2008 period. Once the most skillful model has been selected for each season and variable, this is then applied to GCMs of ENSEMBLES runs. The statistical downscaling method developed reveals good skill over the case studies of the present work, underlying the possibility to apply the scheme over whole Italian peninsula. In addition, the results emphasize that the temperature at 850 hPa is the best predictor for surface air temperature. The future projections show that an increase could be expected to occur under A1B scenario conditions in all seasons, both in minimum and maximum temperatures. The projected increases are about 2 °C during 2021–2050 and between 2.5 and 4.5 °C during 2071–2100, respect to 1961–1990. The spatial distribution of warming is projected to be quite uniform over the territory to the end of the century, while some spatial differences are noted over 2021–2050 period. For example, the increase in minimum temperature is projected to be slightly higher in areas from northern and central part than those situated in the southern part of Italian peninsula, during 2021–2050 period. The peak of changes is projected to appear during summer season, for both minimum and maximum temperature. The probability density function tends to shift to warmer values during both periods, with increases more intense during summer and to the end of the century, when the lower tail is projected to shift up to 3 °C and the upper tail up to 6 °C. All these projected changes have important impacts on viticulture, intensive fruit and tomatoes, some of the main agricultural systems analyzed in the Agroscenari project.
Area: CropM
|
|
Sieber, S., Amjath-Babu, T. S., McIntosh, B. S., Tscherning, K., Müller, K., Helming, K., et al. (2013). Evaluating the characteristics of a non-standardised Model Requirements Analysis (MRA) for the development of policy impact assessment tools. Env. Model. Softw., 49, 53–63.
Abstract: The aim of this paper is to provide a critical analysis of the strengths and weaknesses of a non-standardised Model Requirements Analysis (MRA) used for the purpose of developing the Sustainability Impact Assessment Tool (SIAT). By ‘non-standardised’ we mean not strictly following a published MRA method. The underlying question we are interested in addressing is how non-standardised methods, often employed in research driven projects, compare to defined methods with more standardised structure, with regards their ability to capture model requirements effectively, and with regards their overall usability. Through describing and critically assessing the specific features of the non-standardised MRA employed, the ambition of this paper is to provide insights useful for impact assessment tool (IAT) development. Specifically, the paper will (i) characterise kinds of user requirements relevant to the functionality and design of IATs; (ii) highlight the strengths and weaknesses of non-standardised MRA for user requirements capture, analysis and reflection in the context of IAT; (iii) critically reflect on the process and outcomes of having used a non-standardised MRA in comparison with other more standardised approaches. To accomplish these aims, we first review methods available for IAT development before describing the SIAT development process, including the MRA employed. Major strengths and weaknesses of the MRA method are then discussed in terms of user identification and characterisation, organisational characterisation and embedding, and ability to capture design options for ensuring usability and usefulness. A detailed assessment on the structural differences of MRA with two advanced approaches (Integrated DSS design and goal directed design) and their role in performance of the MRA tool is used to critique the approach employed. The results show that MRA is able to bring thematic integration, establish system performance and technical thresholds as well as detailing quality and transparency guidelines. Nevertheless the discussion points out to a number of deficiencies in application – (i) a need to more effectively characterise potential users, and; (ii) a need to better foster communication among the distinguished roles in the development process. If addressed these deficiencies, SIAT non-standardised MRA could have brought out better outcomes in terms of tool usability and usefulness, and improved embedding of the tool into conditions of targeted end-users. (C) 2013 Elsevier Ltd. All rights reserved.
|