Vitti, C., Stellacci, A. M., Leogrande, R., Mastrangelo, M., Cazzato, E., & Ventrella, D. (2016). Assessment of organic carbon in soils: a comparison between the Springer–Klee wet digestion and the dry combustion methods in Mediterranean soils (Southern Italy). Catena, 137, 113–119.
Abstract: • Comparison of two methods for soil organic C quantification is presented. • Springer–Klee wet digestion and dry combustion with automated analyser were compared. • Soil samples were collected from three different sites in a Southern Italy area. • Recoveries close to one were observed for whole dataset and for data grouped per site. • The strong agreement between the methods would enable direct comparison of results. Abstract Soil organic carbon (SOC) is the largest carbon pool in the terrestrial biosphere and it is among the most important factors responsible for conservation of soil quality. Automated dry combustion techniques are gradually replacing traditional quantification methods based on wet digestion chemistry. Critical comparison of different methods is fundamental to reevaluate archives of SOC data and accurately assess and model long-term carbon stock variation and should be performed for different soil types and management conditions. Two analytical methods, the Springer–Klee wet digestion and the dry combustion using an automated analyser, were compared for soils typical of a Mediterranean environment in Southern Italy. Soil samples were collected from three sites, at two depths. Soils were fine textured (from clay–loam to clay) with total carbonate ranging from 6.6 to 16.7 g 100 g− 1. SOC content varied from 6.92 to 28.86 g kg− 1 (as average of the two methods), with values and ranges typical of Southern Europe. On average, Springer–Klee method gave slightly higher values and showed greater data variability. This behaviour, in agreement with other studies, can be attributed to the reaction of K2Cr2O7 with other soil constituents and to analytical constraints. Our results suggest high consistency between Springer–Klee and dry combustion techniques and show recoveries close to one both for the whole dataset and for data grouped per experimental site or soil depth. Linear regression equations between the two methods were slightly affected by different soil types (P = 0.0621). The best fitting of the relationship was a linear regression passing through the origin for the whole dataset (Radj2 = 0.965; RPD = 3.41). The strong overall agreement observed between the two methods would enable the direct comparison of new data set with those already existing in Southern Italy for soils with similar characteristics.
|
Kersebaum, K., Kroes, J., Gobin, A., Takáč, J., Hlavinka, P., Trnka, M., et al. (2016). Assessing uncertainties of water footprints using an ensemble of crop growth models on winter wheat. Water, 8(12), 571.
Abstract: Crop productivity and water consumption form the basis to calculate the water footprint (WF) of a specific crop. Under current climate conditions, calculated evapotranspiration is related to observed crop yields to calculate WF. The assessment of WF under future climate conditions requires the simulation of crop yields adding further uncertainty. To assess the uncertainty of model based assessments of WF, an ensemble of crop models was applied to data from five field experiments across Europe. Only limited data were provided for a rough calibration, which corresponds to a typical situation for regional assessments, where data availability is limited. Up to eight models were applied for wheat. The coefficient of variation for the simulated actual evapotranspiration between models was in the range of 13%–19%, which was higher than the inter-annual variability. Simulated yields showed a higher variability between models in the range of 17%–39%. Models responded differently to elevated CO2 in a FACE (Free-Air Carbon Dioxide Enrichment) experiment, especially regarding the reduction of water consumption. The variability of calculated WF between models was in the range of 15%–49%. Yield predictions contributed more to this variance than the estimation of water consumption. Transpiration accounts on average for 51%–68% of the total actual evapotranspiration.
|
Boote, K. J., Porter, C., Jones, J. W., Thorburn, P. J., Kersebaum, K. C., Hoogenboom, G., et al. (2016). Sentinel site data for crop model improvement—definition and characterization. In J. L. Hatfield, & D. Fleisher (Eds.), Improving Modeling Tools to Assess Climate Change Effects on Crop Response. Advances in Agricultural Systems Modeling, 7.
Abstract: Crop models are increasingly being used to assess the impacts of future climate change on production and food security. High quality, site-specific data on weather, soils, management, and cultivar are needed for those model applications. Also important is that model development, evaluation, improvement, and calibration require additional high quality, site-specific measurements on crop yield, growth, phenology, and ancillary traits. We review the evolution of minimum data set requirements for agroecosystem modeling and then describe the characteristics and ranking of sentinel site data needed for crop model improvement, calibration, and application. We in the Agricultural Model Intercomparison and Improvement Project (AgMIP), propose to rank sentinel site data sets as platinum, gold, silver, and copper, based on the degree of true site-specific measurement of weather, soils, management, crop yield, as well as the quality, comprehensiveness, quantity, accuracy, and value. For example, to be ranked platinum, the weather and soil characterization must be measured on-site, and all management inputs must be known. Dataset ranking will be lower for weather measured off-site or soil traits estimated from soil mapping. Ranking also depends on the intended purposes for data use. If the purpose is to improve a crop model for response to water or N, then additional observations are necessary, such as initial soil water, initial soil inorganic N, and plant N uptake during the growing season to be ranked platinum. Rankings are enhanced by presence of multiple treatments and sites. Examples of platinum-, gold-, and silver-quality data sets for model improvement and calibration uses are illustrated.
|
Ginaldi, F., Bindi, M., Marta, A. D., Ferrise, R., Orlandini, S., & Danuso, F. (2016). Interoperability of agronomic long term experiment databases and crop model intercomparison: the Italian experience. Europ. J. Agron., 77, 209–222.
Abstract: • ICFAR-DB organises and stores data from 16 Italian long term agronomic experiments. • ICFAR-DB fulfils interoperability using system dynamics ontology and AgMIP nomenclature. • ICFAR information management system moves closer data to model and vice versa. The IC-FAR national project (Linking long term observatories with crop system modelling for better understanding of climate change impact, and adaptation strategies for Italian cropping systems) initiated in 2013 with the primary aim of implementing data from 16 long term Italian agronomic experiments in a common, interoperable structure. The building of a common database (DB) structure demands a harmonization process aimed at standardising concepts, language and data in order to make them clear, and has to produce a well-documented and easily available tool for the whole scientific community. The Agricultural Model Intercomparison and Improvement Project (AgMIP) has made a great effort in this sense, improving the vocabulary developed by the International Consortium for Agricultural Systems Applications (ICASA) and defining harmonization procedures. Nowadays, these ones have also to be addressed to facilitate the extraction of input files for crop model simulations. Substantially, two alternative directions can be pursued: adapting data to models, building a standard storage structure and using translators that convert DB information to model input files; or adapting models to data, using the same storage structure for feeding modelling solutions constituted by combining model components, re-implemented in the same model platform. The ICFAR information management system simplifies data entry, improves model input extraction (implementing System Dynamics ontology), and satisfies both the paradigms. This has required the development of different software tools: ICFAR-DB for data entry and storage; a model input extractor for feeding the crop models (MoLInEx); SEMoLa platform for building modelling solutions and performing via scripts the model intercomparison. The use of the standard AgMIP/ICASA nomenclature in the ICFAR-DB and the opportunity to create files with MoLInex for feeding AgMIP model translators allow full system interoperability.
|
Liu, B., Asseng, S., Müller, C., Ewert, F., Elliott, J., Lobell, D. B., et al. (2016). Similar estimates of temperature impacts on global wheat yield by three independent methods. Nat. Clim. Change, 6(12), 1130–1136.
|