| Home | << 1 2 3 4 >> |
|
Ma, S., Lardy, R., Graux, A. - I., Ben Touhami, H., Klumpp, K., Martin, R., et al. (2015). Regional-scale analysis of carbon and water cycles on managed grassland systems. Env. Model. Softw., 72, 356–371.
Abstract: Predicting regional and global carbon (C) and water dynamics on grasslands has become of major interest, as grasslands are one of the most widespread vegetation types worldwide, providing a number of ecosystem services (such as forage production and C storage). The present study is a contribution to a regional-scale analysis of the C and water cycles on managed grasslands. The mechanistic biogeochemical model PaSim (Pasture Simulation model) was evaluated at 12 grassland sites in Europe. A new parameterization was obtained on a common set of eco-physiological parameters, which represented an improvement of previous parameterization schemes (essentially obtained via calibration at specific sites). We found that C and water fluxes estimated with the parameter set are in good agreement with observations. The model with the new parameters estimated that European grassland are a sink of C with 213 g C m(-2) yr(-1), which is close to the observed net ecosystem exchange (NEE) flux of the studied sites (185 g C m(-2) yr(-1) on average). The estimated yearly average gross primary productivity (GPP) and ecosystem respiration (RECO) for all of the study sites are 1220 and 1006 g C m(-2) yr(-1), respectively, in agreement with observed average GPP (1230 g C m(-2) yr(-1)) and RECO (1046 g C m(-2) yr(-1)). For both variables aggregated on a weekly basis, the root mean square error (RMSE) was similar to 5-16 g C week(-1) across the study sites, while the goodness of fit (R-2) was similar to 0.4-0.9. For evapotranspiration (ET), the average value of simulated ET (415 mmyr(-1)) for all sites and years is close to the average value of the observed ET (451 mm yr(-1)) by flux towers (on a weekly basis, RMSE similar to 2-8 mm week(-1); R-2 = 0.3-0.9). However, further model development is needed to better represent soil water dynamics under dry conditions and soil temperature in winter. A quantification of the uncertainties introduced by spatially generalized parameter values in C and water exchange estimates is also necessary. In addition, some uncertainties in the input management data call for the need to improve the quality of the observational system.
Keywords: carbon flux; eddy flux measurements; model evaluation; pasture simulation model (pasim); water balance; pasture simulation-model; nitrous-oxide emissions; primary productivity npp; comparing global-models; net ecosystem exchange; greenhouse-gas balance; climate-change; agricultural systems; co2 exchange; european grasslands
|
|
Sándor, R., Ma, S., Acutis, M., Barcza, Z., Ben Touhami, H., Doro, L., et al. (2015). Uncertainty in simulating biomass yield and carbon–water fluxes from grasslands under climate change. Advances in Animal Biosciences, 6(01), 49–51.
|
|
Sieber, S., Amjath-Babu, T. S., Jansson, T., Müller, K., Tscherning, K., Graef, F., et al. (2013). Sustainability impact assessment using integrated meta-modelling: Simulating the reduction of direct support under the EU common agricultural policy (CAP). Land Use Policy, 33, 235–245.
Abstract: Assessing the impact of macro-level policy driven land use changes on regional sustainability is an important task that can facilitate complex decision making processes of introducing reforms. The research work demonstrates the ability of Sustainability Impact Assessment Tool (SIAT), a meta-model, in conducting ex ante spatially explicit cross sectoral impact assessments of changes in common agricultural policy (CAP). The meta-model is able to appraise impacts of CAP amendments on land use and their repercussions on multiple indicators of sustainability. The presented study comprehensively analyses the possible impacts of discontinuing direct financial support to farmers under CAP. The simulations of the meta-model are able to reveal the land use changes both at EU and regional levels as well as to bring forth the subsequent changes in a number of indicators representing the regional sustainability (for five case study regions). In a nutshell, the simulations indicate that a reduction in direct support brings in general, a decrease in farmed area, an increase in forested land, less fluctuation in natural vegetation coverage, increase in abandoned arable land area and negligible changes in built-up area despite regionally diverging land use trends. The simulated changes in sustainability indicators for the study regions in consequence to these land use changes show that the discontinuation of subsidies evokes responses that are in general climate friendly (reduction in methane and N2O emissions, diminishing energy use and reduction in global warming potential), economically beneficial (increase in gross value of agriculture) and socially desired (decrease in unemployment rate) as well as environmentally harmful (increase in pesticide use). Even though the appraisals of diversity indicators such as forest deadwood and farmland birds are not conclusive for all regions, the changes are positive for the former indicator and slightly negative for the latter in general. The trade-offs among these regional sustainability indicators using their directional associations are also presented for a comprehensive assessment of the impacts. (C) 2013 Elsevier Ltd. All rights reserved.
Keywords: SIAT; CAP; sustainability; impact assessment; land use change; trade off analysis; model; Netherlands; systems
|
|
Sieber, S., Amjath-Babu, T. S., McIntosh, B. S., Tscherning, K., Müller, K., Helming, K., et al. (2013). Evaluating the characteristics of a non-standardised Model Requirements Analysis (MRA) for the development of policy impact assessment tools. Env. Model. Softw., 49, 53–63.
Abstract: The aim of this paper is to provide a critical analysis of the strengths and weaknesses of a non-standardised Model Requirements Analysis (MRA) used for the purpose of developing the Sustainability Impact Assessment Tool (SIAT). By ‘non-standardised’ we mean not strictly following a published MRA method. The underlying question we are interested in addressing is how non-standardised methods, often employed in research driven projects, compare to defined methods with more standardised structure, with regards their ability to capture model requirements effectively, and with regards their overall usability. Through describing and critically assessing the specific features of the non-standardised MRA employed, the ambition of this paper is to provide insights useful for impact assessment tool (IAT) development. Specifically, the paper will (i) characterise kinds of user requirements relevant to the functionality and design of IATs; (ii) highlight the strengths and weaknesses of non-standardised MRA for user requirements capture, analysis and reflection in the context of IAT; (iii) critically reflect on the process and outcomes of having used a non-standardised MRA in comparison with other more standardised approaches. To accomplish these aims, we first review methods available for IAT development before describing the SIAT development process, including the MRA employed. Major strengths and weaknesses of the MRA method are then discussed in terms of user identification and characterisation, organisational characterisation and embedding, and ability to capture design options for ensuring usability and usefulness. A detailed assessment on the structural differences of MRA with two advanced approaches (Integrated DSS design and goal directed design) and their role in performance of the MRA tool is used to critique the approach employed. The results show that MRA is able to bring thematic integration, establish system performance and technical thresholds as well as detailing quality and transparency guidelines. Nevertheless the discussion points out to a number of deficiencies in application – (i) a need to more effectively characterise potential users, and; (ii) a need to better foster communication among the distinguished roles in the development process. If addressed these deficiencies, SIAT non-standardised MRA could have brought out better outcomes in terms of tool usability and usefulness, and improved embedding of the tool into conditions of targeted end-users. (C) 2013 Elsevier Ltd. All rights reserved.
|