|
|
Zhao, G., Hoffmann, H., van Bussel, L. G. J., Enders, A., Specka, X., Sosa, C., et al. (2015). Effect of weather data aggregation on regional crop simulation for different crops, production conditions, and response variables. Clim. Res., 65, 141–157.
Abstract: We assessed the weather data aggregation effect (DAE) on the simulation of cropping systems for different crops, response variables, and production conditions. Using 13 process-based crop models and the ensemble mean, we simulated 30 yr continuous cropping systems for 2 crops (winter wheat and silage maize) under 3 production conditions for the state of North Rhine-Westphalia, Germany. The DAE was evaluated for 5 weather data resolutions (i.e. 1, 10, 25, 50, and 100 km) for 3 response variables including yield, growing season evapotranspiration, and water use efficiency. Five metrics, viz. the spatial bias (Delta), average absolute deviation (AAD), relative AAD, root mean squared error (RMSE), and relative RMSE, were used to evaluate the DAE on both the input weather data and simulated results. For weather data, we found that data aggregation narrowed the spatial variability but widened the., especially across mountainous areas. The DAE on loss of spatial heterogeneity and hotspots was stronger than on the average changes over the region. The DAE increased when coarsening the spatial resolution of the input weather data. The DAE varied considerably across different models, but changed only slightly for different production conditions and crops. We conclude that if spatially detailed information is essential for local management decision, higher resolution is desirable to adequately capture the spatial variability for heterogeneous regions. The required resolution depends on the choice of the model as well as the environmental condition of the study area.
|
|
|
|
Webber, H., Gaiser, T., Oomen, R., Teixeira, E., Zhao, G., Wallach, D., et al. (2016). Uncertainty in future irrigation water demand and risk of crop failure for maize in Europe. Environ. Res. Lett., .
Abstract: While crop models are widely used to assess the change in crop productivity with climate change, their skill in assessing irrigation water demand or the risk of crop failure in large area impact assessments is relatively unknown. The objective of this study is to investigate which aspects of modeling crop water use (reference crop evapotranspiration (ET0), soil water extraction, soil evaporation, soil water balance and root growth) contributes most to the variability in estimates of maize crop water use and the risk of crop failure, and demonstrate the resulting uncertainty in a climate change impact study for Europe. The SIMPLACE crop modeling framework was used to couple the LINTUL5 crop model in factorial combinations of 2-3 different approaches for simulating the 5 aspects of crop water use, resulting in 51 modeling approaches. Using experiments in France and New Zeland, analysis of total sensitivity revealed that ET0 explained the most variability in both irrigated maize water use and rainfed grain yield levels, with soil evaporation also imporatant in the French experiment. In the European impact study, net irrigation requirement differed by 36% between the Penman and Hargreaves ET0 methods in the baseline period. Average EU grain yields were similar between models, but differences approached 1-2 tonnes in parts of France and Southern Europe. EU wide esimates of crop failure in the historical period ranged between 5.4 years for Priestley-Taylor to every 7.9 years for the Penman ET0 methods. While the uncertainty in absolute values between models was significant, estimates of relative changes were similar between models, confirming the utility of crop models in assessing climate change impacts. If ET0 estimates in crop models can be improved, through the use of appropriate methods, uncertainty in irrigation water demand as well as in yield estimates under drought can be reduced.
|
|
|
|
Webber, H., Martre, P., Asseng, S., Kimball, B., White, J., Ottman, M., et al. (2017). Canopy temperature for simulation of heat stress in irrigated wheat in a semi-arid environment: A multi-model comparison. Field Crops Research, 202, 21–35.
Abstract: Even brief periods of high temperatures occurring around flowering and during grain filling can severely reduce grain yield in cereals. Recently, ecophysiological and crop models have begun to represent such phenomena. Most models use air temperature (Tair) in their heat stress responses despite evidence that crop canopy temperature (Tc) better explains grain yield losses. Tc can deviate significantly from Tair based on climatic factors and the crop water status. The broad objective of this study was to evaluate whether simulation of Tc improves the ability of crop models to simulate heat stress impacts on wheat under irrigated conditions. Nine process-based models, each using one of three broad approaches (empirical, EMP; energy balance assuming neutral atmospheric stability, EBN; and energy balance correcting for the atmospheric stability conditions, EBSC) to simulate Tc, simulated grain yield under a range of temperature conditions. The models varied widely in their ability to reproduce the measured Tc with the commonly used EBN models performing much worse than either EMP or EBSC. Use of Tc to account for heat stress effects did improve simulations compared to using only Tair to a relatively minor extent, but the models that additionally use Tc on various other processes as well did not have better yield simulations. Models that simulated yield well under heat stress had varying skill in simulating Tc. For example, the EBN models had very poor simulations of Tc but performed very well in simulating grain yield. These results highlight the need to more systematically understand and model heat stress events in wheat.
|
|
|
|
Hlavinka, P., Kersebaum, K. C., Dubrovský, M., Fischer, M., Pohanková, E., Balek, J., et al. (2015). Water balance, drought stress and yields for rainfed field crop rotations under present and future conditions in the Czech Republic. Clim. Res., 65, 175–192.
Abstract: Continuous crop rotation modeling is a prospective trend that, compared to 1-crop or discrete year-by-year calculations, can provide more accurate results that are closer to real conditions. The goal of this study was to compare the water balance and yields estimated by the HERMES crop rotation model for present and future climatic conditions in the Czech Republic. Three locations were selected, representing important agricultural regions with different climatic conditions. Crop rotation (spring barley, silage maize, winter wheat, winter rape) was simulated from 1981-2080. The 1981-2010 period was covered by measured meteorological data, while 2011-2080 was represented by a transient synthetic weather series from the weather generator M& Rfi. The data were based on 5 circulation models, representing an ensemble of 18 CMIP3 global circulation models, to preserve much of the uncertainty of the original ensemble. Two types of crop management were compared, and the influences of soil quality, increasing atmospheric CO2 and adaptation measures (i. e. sowing date changes) were also considered. Results suggest that under a ‘dry’ scenario (such as GFCM21), C-3 crops in drier regions will be devastated for a significant number of seasons. Negative impacts are likely even on premium-quality soils regardless of flexible sowing dates and accounting for increasing CO2 concentrations. Moreover, in dry conditions, the use of crop rotations with catch crops may have negative impacts, exacerbating the soil water deficit for subsequent crops. This approach is a promising method for determining how various management strategies and crop rotations can affect yields as well as water, carbon and nitrogen cycling.
|
|
|
|
Himanen, S. J., Ketoja, E., Hakala, K., Rötter, R. P., Salo, T., & Kahiluoto, H. (2013). Cultivar diversity has great potential to increase yield for feed barley. Agron. Sust. Developm., 33(3), 519–530.
Abstract: This study shows an average yield increase of 415–1,338 kg ha−1 per unit increase of the Shannon diversity index for feed barley cultivar use. There is a global quest to increase food production sustainably. Therefore, judicious farmer choices such as selection of crop cultivars are increasingly important. Cultivar diversity is limited and, as a consequence, corresponding crop yields are highly impacted by local weather variations and global climate change. Actually, there is little knowledge on the relationships between yields of regional crops and cultivar diversity, that is evenness and richness in cultivar use. Here, we hypothesized that higher cultivar diversity is related to higher regional yield. We also assumed that the diversity-yield relationship depends on weather during the growing season. Our data were based on farm yield surveys of feed and malting barley, Hordeum vulgare L.; spring wheat, Triticum aestivum L.; and spring turnip rape, Brassica rapa L. ssp. oleifera, from 1998 to 2009, representing about 4,500–5,500 farms annually. We modeled the relationships between regional yields and Shannon diversity indices in high-yielding (south-west) and low-yielding (central-east) regions of Finland using linear mixed models. Our results show that an increase of Shannon diversity index increases yield of feed barley. Feed barley had also the greatest cultivar diversity. In contrast, an average yield decrease of 1,052 kg ha−1 per unit increase in Shannon index was found for spring rape in 2006 and 2008. Our findings show that cultivar diversification has potential to raise mean regional yield of feed barley. Increasing cultivar diversity thus offers a novel, sustainability-favoring means to promote higher yields.
|
|
