| Home | [21–30] << 31 32 33 34 35 36 37 38 39 40 >> [41–50] |
|
Dáder, B., Plaza, M., Fereres, A., & Moreno, A. (2015). Flight behaviour of vegetable pests and their natural enemies under different ultraviolet-blocking enclosures. Ann. Appl. Biol., 167(1), 116–126.
Abstract: Ultraviolet (UV) radiation, particularly in the UV-A + B range (280-400 nm) is a fraction of the solar spectrum that regulates almost every aspect of insect behaviour, including orientation towards hosts, alighting, arrestment and feeding behaviour. To study the role of UV radiation on the flight activity of five insect species of agricultural importance (pests Myzus persicae, Bemisia tabaci and Tuta absoluta, and natural enemies Aphidius colemani and Sphaerophoria rueppellii), one-chamber tunnels were covered with six cladding materials with different light transmittance properties ranging from 2% to 83% UV and 54% to 85% photosynthetically active radiation (PAR). Inside each tunnel, insects were released from tubes placed in a platform suspended from the ceiling. Specific targets varying with insect species were placed at different distances from the platform. Evaluation parameters were designed for each insect and tested separately. The ability of insects to leave the platform was assessed, as well as the number of captures, eggs or mummies in each target, either sticky traps or plants. Our results suggest differences in flight activity among insect species and UV-blocking nets. The UV-opaque film drastically prevented aphids, and whiteflies from flying outside the tubes whereas T. absoluta, syrphids and parasitoids were not affected. Aphid flight behaviour was affected by the UV-opaque film compared to the other nets, especially in the furthest target of the tunnel. Fewer aphids reached distant traps under UV-absorbing nets, and significantly more aphids could fly to the end of tunnels covered with non-UV-blocking materials. Orientation of B. tabaci and T. absoluta was also negatively affected by the UV-opaque film although in a different trend. Unlike aphids, differences in B. tabaci captures were mainly found in the closest targets. UV transmittance did not have any effects on parasitoids, and S. rueppellii, implying cues other than visual for these insects under our experimental conditions. Further effects of photoselective enclosures on greenhouse pests and their natural enemies are discussed.
|
|
Hakala, K., Jauhiainen, L., Himanen, S. J., RÖTter, R., Salo, T., & Kahiluoto, H. (2012). Sensitivity of barley varieties to weather in Finland. J. Agric. Sci., 150(02), 145–160.
Abstract: Global climate change is predicted to shift seasonal temperature and precipitation patterns. An increasing frequency of extreme weather events such as heat waves and prolonged droughts is predicted, but there are high levels of uncertainty about the nature of local changes. Crop adaptation will be important in reducing potential damage to agriculture. Crop diversity may enhance resilience to climate variability and changes that are difficult to predict. Therefore, there has to be sufficient diversity within the set of available cultivars in response to weather parameters critical for yield formation. To determine the scale of such ‘weather response diversity’ within barley (Hordeum vulgare L.), an important crop in northern conditions, the yield responses of a wide range of modern and historical varieties were analysed according to a well-defined set of critical agro-meteorological variables. The Finnish long-term dataset of MTT Official Variety Trials was used together with historical weather records of the Finnish Meteorological Institute. The foci of the analysis were firstly to describe the general response of barley to different weather conditions and secondly to reveal the diversity among varieties in the sensitivity to each weather variable. It was established that barley yields were frequently reduced by drought or excessive rain early in the season, by high temperatures at around heading, and by accelerated temperature sum accumulation rates during periods 2 weeks before heading and between heading and yellow ripeness. Low temperatures early in the season increased yields, but frost during the first 4 weeks after sowing had no effect. After canopy establishment, higher precipitation on average resulted in higher yields. In a cultivar-specific analysis, it was found that there were differences in responses to all but three of the studied climatic variables: waterlogging and drought early in the season and temperature sum accumulation rate before heading. The results suggest that low temperatures early in the season, delayed sowing, rain 3-7 weeks after sowing, a temperature change 3-4 weeks after sowing, a high temperature sum accumulation rate from heading to yellow ripeness and high temperatures (25 degrees C) at around heading could mostly be addressed by exploiting the traits found in the range of varieties included in the present study. However, new technology and novel genetic material are needed to enable crops to withstand periods of excessive rain or drought early in the season and to enhance performance under increased temperature sum accumulation rates prior to heading.
|
|
Zheng, B., Chapman, S. C., Christopher, J. T., Frederiks, T. M., & Chenu, K. (2015). Frost trends and their estimated impact on yield in the Australian wheatbelt. J. Experim. Bot., 66(12), 3611–3623.
Abstract: Radiant spring frosts occurring during reproductive developmental stages can result in catastrophic yield loss for wheat producers. To better understand the spatial and temporal variability of frost, the occurrence and impact of frost events on rain-fed wheat production was estimated across the Australian wheatbelt for 1957-2013 using a 0.05 ° gridded weather data set. Simulated yield outcomes at 60 key locations were compared with those for virtual genotypes with different levels of frost tolerance. Over the last six decades, more frost events, later last frost day, and a significant increase in frost impact on yield were found in certain regions of the Australian wheatbelt, in particular in the South-East and West. Increasing trends in frost-related yield losses were simulated in regions where no significant trend of frost occurrence was observed, due to higher mean temperatures accelerating crop development and causing sensitive post-heading stages to occur earlier, during the frost risk period. Simulations indicated that with frost-tolerant lines the mean national yield could be improved by up to 20% through (i) reduced frost damage (~10% improvement) and (ii) the ability to use earlier sowing dates (adding a further 10% improvement). In the simulations, genotypes with an improved frost tolerance to temperatures 1 °C lower than the current 0 °C reference provided substantial benefit in most cropping regions, while greater tolerance (to 3 °C lower temperatures) brought further benefits in the East. The results indicate that breeding for improved reproductive frost tolerance should remain a priority for the Australian wheat industry, despite warming climates.
Keywords: Adaptation, Physiological/genetics; Australia; Computer Simulation; Ecotype; *Freezing; Genotype; Geography; Seasons; Triticum/genetics/*growth & development/physiology; Breeding; climate change; crop adaptation; crop modelling; ideotype; post-head-emergence frost; reproductive frost; spring radiant frost
|
|
De Swaef, T., Bellocchi, G., Aper, J., Lootens, P., & Roldan-Ruiz, I. (2019). Use of identifiability analysis in designing phenotyping experiments for modelling forage production and quality. J. Experim. Bot., 70(9), 2587–2604.
Abstract: Agricultural systems models are complex and tend to be over-parameterized with respect to observational datasets. Practical identifiability analysis based on local sensitivity analysis has proved effective in investigating identifiable parameter sets in environmental models, but has not been applied to agricultural systems models. Here, we demonstrate that identifiability analysis improves experimental design to ensure independent parameter estimation for yield and quality outputs of a complex grassland model. The Pasture Simulation model (PaSim) was used to demonstrate the effectiveness of practical identifiability analysis in designing experiments and measurement protocols within phe-notyping experiments with perennial ryegrass. Virtual experiments were designed combining three factors: frequency of measurements, duration of the experiment. and location of trials. Our results demonstrate that (i) PaSim provides sufficient detail in terms of simulating biomass yield and quality of perennial ryegrass for use in breeding, (ii) typical breeding trials are insufficient to parameterize all influential parameters, (iii) the frequency of measurements is more important than the number of growing seasons to improve the identifiability of PaSim parameters, and (iv) identifiability analysis provides a sound approach for optimizing the design of multi-location trials. Practical identifiability analysis can play an important role in ensuring proper exploitation of phenotypic data and cost-effective multi-location experimental designs. Considering the growing importance of simulation models, this study supports the design of experiments and measurement protocols in the phenotyping networks that have recently been organized.
|
|
Rötter, R. P., Tao, F., Höhn, J. G., & Palosuo, T. (2015). Use of crop simulation modelling to aid ideotype design of future cereal cultivars. J. Experim. Bot., 66(12), 3463–3476.
Abstract: A major challenge of the 21st century is to achieve food supply security under a changing climate and roughly a doubling in food demand by 2050 compared to present, the majority of which needs to be met by the cereals wheat, rice, maize, and barley. Future harvests are expected to be especially threatened through increased frequency and severity of extreme events, such as heat waves and drought, that pose particular challenges to plant breeders and crop scientists. Process-based crop models developed for simulating interactions between genotype, environment, and management are widely applied to assess impacts of environmental change on crop yield potentials, phenology, water use, etc. During the last decades, crop simulation has become important for supporting plant breeding, in particular in designing ideotypes, i.e. ‘model plants’, for different crops and cultivation environments. In this review we (i) examine the main limitations of crop simulation modelling for supporting ideotype breeding, (ii) describe developments in cultivar traits in response to climate variations, and (iii) present examples of how crop simulation has supported evaluation and design of cereal cultivars for future conditions. An early success story for rice demonstrates the potential of crop simulation modelling for ideotype breeding. Combining conventional crop simulation with new breeding methods and genetic modelling holds promise to accelerate delivery of future cereal cultivars for different environments. Robustness of model-aided ideotype design can further be enhanced through continued improvements of simulation models to better capture effects of extremes and the use of multi-model ensembles.
|