Home | [41–50] << 51 52 53 54 55 56 57 58 59 60 >> [61–70] |
![]() |
Rusu, T., Moraru, P. I., Bogdan, I., Pop, A., Coste, C., Marin, D. I., et al. (2013). Impacts of climate change on agricultural technology management in the Transylvanian Plain, Romania. Scientific Papers, Series A. Agronomy, Lvi, 113–118.
Abstract: The Transylvanian Plain, Romania is an important region for agronomic productivity. However, limited soils data and adoption of best management practices hinder land productivity. Soil temperatures of the Transylvanian Plain were evaluated using a set of twenty datalogging stations positioned throughout the plain. Each station stores electronic data of ground temperature on 3 different levels of depth (10, 30 and 50 cm), of soil humidity at a depth of 10 cm, of the air temperature at 1 meter and of precipitation. Monitoring the thermal and hydric regime of the area is essential in order to identify and implement sets of measures of adjustment to the impact of climatic changes. After analyzing the recorded data, thermic and hydric, in the Transylvanian Plain, we recommend as optimal sowing period, advancing those known in the literature, with 5 days for corn and soybeans, and maintaining the same optimum period for sunflower and sugar beet. Water requirements are provided in an optimum, of 58.8 to 62.1% for the spring weeding crops during the growing season, thus irrigation is necessary to ensure optimum production potential. The amount of biological active degrees registered in Transylvanian Plain shows the necessity to reconstruct crop zoning, known in the literature, for the analyzed crops: wheat, corn, soy, sunflower and sugar beet.
|
Vitti, C., Stellacci, A. M., Leogrande, R., Mastrangelo, M., Cazzato, E., & Ventrella, D. (2016). Assessment of organic carbon in soils: a comparison between the Springer–Klee wet digestion and the dry combustion methods in Mediterranean soils (Southern Italy). Catena, 137, 113–119.
Abstract: • Comparison of two methods for soil organic C quantification is presented. • Springer–Klee wet digestion and dry combustion with automated analyser were compared. • Soil samples were collected from three different sites in a Southern Italy area. • Recoveries close to one were observed for whole dataset and for data grouped per site. • The strong agreement between the methods would enable direct comparison of results. Abstract Soil organic carbon (SOC) is the largest carbon pool in the terrestrial biosphere and it is among the most important factors responsible for conservation of soil quality. Automated dry combustion techniques are gradually replacing traditional quantification methods based on wet digestion chemistry. Critical comparison of different methods is fundamental to reevaluate archives of SOC data and accurately assess and model long-term carbon stock variation and should be performed for different soil types and management conditions. Two analytical methods, the Springer–Klee wet digestion and the dry combustion using an automated analyser, were compared for soils typical of a Mediterranean environment in Southern Italy. Soil samples were collected from three sites, at two depths. Soils were fine textured (from clay–loam to clay) with total carbonate ranging from 6.6 to 16.7 g 100 g− 1. SOC content varied from 6.92 to 28.86 g kg− 1 (as average of the two methods), with values and ranges typical of Southern Europe. On average, Springer–Klee method gave slightly higher values and showed greater data variability. This behaviour, in agreement with other studies, can be attributed to the reaction of K2Cr2O7 with other soil constituents and to analytical constraints. Our results suggest high consistency between Springer–Klee and dry combustion techniques and show recoveries close to one both for the whole dataset and for data grouped per experimental site or soil depth. Linear regression equations between the two methods were slightly affected by different soil types (P = 0.0621). The best fitting of the relationship was a linear regression passing through the origin for the whole dataset (Radj2 = 0.965; RPD = 3.41). The strong overall agreement observed between the two methods would enable the direct comparison of new data set with those already existing in Southern Italy for soils with similar characteristics.
|
Schils, R., Olesen, J. E., Kersebaum, K. - C., Rijk, B., Oberforster, M., Kalyada, V., et al. (2018). Cereal yield gaps across Europe. Europ. J. Agron., 101, 109–120.
Abstract: Europe accounts for around 20% of the global cereal production and is a net exporter of ca. 15% of that production. Increasing global demand for cereals justifies questions as to where and by how much Europe’s production can be increased to meet future global market demands, and how much additional nitrogen (N) crops would require. The latter is important as environmental concern and legislation are equally important as production aims in Europe. Here, we used a country-by-country, bottom-up approach to establish statistical estimates of actual grain yield, and compare these to modelled estimates of potential yields for either irrigated or rainfed conditions. In this way, we identified the yield gaps and the opportunities for increased cereal production for wheat, barley and maize, which represent 90% of the cereals grown in Europe. The combined mean annual yield gap of wheat, barley, maize was 239 Mt, or 42% of the yield potential. The national yield gaps ranged between 10 and 70%, with small gaps in many north-western European countries, and large gaps in eastern and south-western Europe. Yield gaps for rainfed and irrigated maize were consistently lower than those of wheat and barley. If the yield gaps of maize, wheat and barley would be reduced from 42% to 20% of potential yields, this would increase annual cereal production by 128 Mt (39%). Potential for higher cereal production exists predominantly in Eastern Europe, and half of Europe’s potential increase is located in Ukraine, Romania and Poland. Unlocking the identified potential for production growth requires a substantial increase of the crop N uptake of 4.8 Mt. Across Europe, the average N uptake gaps, to achieve 80% of the yield potential, were 87, 77 and 43 kg N ha(-1) for wheat, barley and maize, respectively. Emphasis on increasing the N use efficiency is necessary to minimize the need for additional N inputs. Whether yield gap reduction is desirable and feasible is a matter of balancing Europe’s role in global food security, farm economic objectives and environmental targets.
|
Toscano, P., Ranieri, R., Matese, A., Vaccari, F. P., Gioli, B., Zaldei, A., et al. (2012). Durum wheat modeling: The Delphi system, 11 years of observations in Italy. European Journal of Agronomy, 43, 108–118.
Abstract: ► Delphi system, based on AFRCWHEAT2 model, for durum wheat forecast. ► AFRCWHEAT2 model was calibrated and validated for three years. ► A scenario approach was applied to simulation of durum wheat yield. ► Operational mode for eleven years in rainfed and water limiting conditions. ► Accurate forecast as an useful planning tool. Crop models are frequently used in ecology, agronomy and environmental sciences for simulating crop and environmental variables at a discrete time step. The aim of this work was to test the predictive capacity of the Delphi system, calibrated and determined for each pedoclimatic factor affecting durum wheat during phenological development. at regional scale. We present an innovative system capable of predicting spatial yield variation and temporal yield fluctuation in long-term analysis, that are the main purposes of regional crop simulation study. The Delphi system was applied to simulate growth and yield of durum wheat in the major Italian supply basins (Basilicata, Capitanata, Marche, Tuscany). The model was validated and evaluated for three years (1995-1997) at 11 experimental fields and then used in operational mode for eleven years (1999-2009), showing an excellent/good accuracy in predicting grain yield even before maturity for a wide range of growing conditions in the Mediterranean climate, governed by different annual weather patterns. The results were evaluated on the basis of regression and normalized root mean squared error with known crop yield statistics at regional level. (c) 2012 Elsevier B.V. All rights reserved.
|
Angulo, C., Rötter, R., Trnka, M., Pirttioja, N., Gaiser, T., Hlavinka, P., et al. (2013). Characteristic ‘fingerprints’ of crop model responses to weather input data at different spatial resolutions. European Journal of Agronomy, 49, 104–114.
Abstract: Crop growth simulation models are increasingly used for regionally assessing the effects of climate change and variability on crop yields. These models require spatially and temporally detailed, location-specific, environmental (weather and soil) and management data as inputs, which are often difficult to obtain consistently for larger regions. Aggregating the resolution of input data for crop model applications may increase the uncertainty of simulations to an extent that is not well understood. The present study aims to systematically analyse the effect of changes in the spatial resolution of weather input data on yields simulated by four crop models (LINTUL-SLIM, DSSAT-CSM, EPIC and WOFOST) which were utilized to test possible interactions between weather input data resolution and specific modelling approaches representing different degrees of complexity. The models were applied to simulate grain yield of spring barley in Finland for 12 years between 1994 and 2005 considering five spatial resolutions of daily weather data: weather station (point) and grid-based interpolated data at resolutions of 10 km x 10 km; 20 km x 20 km; 50 km x 50 km and 100 km x 100 km. Our results show that the differences between models were larger than the effect of the chosen spatial resolution of weather data for the considered years and region. When displaying model results graphically, each model exhibits a characteristic ‘fingerprint’ of simulated yield frequency distributions. These characteristic distributions in response to the inter-annual weather variability were independent of the spatial resolution of weather input data. Using one model (LINTUL-SLIM), we analysed how the aggregation strategy, i.e. aggregating model input versus model output data, influences the simulated yield frequency distribution. Results show that aggregating weather data has a smaller effect on the yield distribution than aggregating simulated yields which causes a deformation of the model fingerprint. We conclude that changes in the spatial resolution of weather input data introduce less uncertainty to the simulations than the use of different crop models but that more evaluation is required for other regions with a higher spatial heterogeneity in weather conditions, and for other input data related to soil and crop management to substantiate our findings. Our results provide further evidence to support other studies stressing the importance of using not just one, but different crop models in climate assessment studies. (C) 2013 Elsevier B.V. All rights reserved.
|