|
|
Roggero, P. P. (2013). Strategies for engagement on adaptation and mitigation with national and EU policy makers and with the agro-food chain sector (Vol. 2).
Abstract: A process for the strategic mapping of national and EU policy makers to be engaged in an interactive and iterative process of learning was designed, based on literature review and specific experience of some participants. In this first intermediate version, we propose a stakeholder mapping process design which will ideally lead to setting the boundaries of context-sensitive systems of interest for pilot actions or interdisciplinary case studies. The mapping exercise will be tested by participants No Label
|
|
|
|
Conradt, T., Wechsung, F., & Bronstert, A. (2013). Three perceptions of the evapotranspiration landscape: comparing spatial patterns from a distributed hydrological model, remotely sensed surface temperatures, and sub-basin water balances. Hydrol. Earth System Sci., 17(7), 2947–2966.
Abstract: A problem encountered by many distributed hydrological modelling studies is high simulation errors at interior gauges when the model is only globally calibrated at the outlet. We simulated river runoff in the Elbe River basin in central Europe (148 268 km(2)) with the semi-distributed eco-hydrological model SWIM (Soil and Water Integrated Model). While global parameter optimisation led to Nash-Sutcliffe efficiencies of 0.9 at the main outlet gauge, comparisons with measured runoff series at interior points revealed large deviations. Therefore, we compared three different strategies for deriving sub-basin evapotranspiration: (1) modelled by SWIM without any spatial calibration, (2) derived from remotely sensed surface temperatures, and (3) calculated from long-term precipitation and discharge data. The results show certain consistencies between the modelled and the remote sensing based evapotranspiration rates, but there seems to be no correlation between remote sensing and water balance based estimations. Subsequent analyses for single sub-basins identify amongst others input weather data and systematic error amplification in inter-gauge discharge calculations as sources of uncertainty. The results encourage careful utilisation of different data sources for enhancements in distributed hydrological modelling.
|
|
|
|
Perego, A., Giussani, A., Fumagalli, M., Sanna, M., Chiodini, M., Carozzi, M., et al. (2013). Crop rotation, fertilizer types and application timing affecting nitrogen leaching in nitrate vulnerable zones in Po Valley. Italian Journal of Agrometeorology, 3(2), 39–50.
Abstract: A critical analysis was performed to evaluate the potential risk of nitrate leaching towards groundwater in three Nitrate Vulnerable Zones (NVZs) of the Lombardia plain by applying the ARMOSA crop simulation model over a 20 years period (1988-2007). Each studied area was characterized by (i) two representative soil types, (ii) a meteorological data set, (iii) four crop rotations according to the regional land use, (iv) organic N load, calculated on the basis of livestock density. We simulated 3 scenarios defined by different fertilization time and amount of mineral and organic fertilizers. The A scenario involved no limitation in organic N application, while under the B and C scenarios the N organic amount was 170 and 250 kg N ha(-1)y(-1), respectively. The C scenario was compliant with the requirement of the 2012 Italian derogation, allowing only the use of organic manure with an efficiency greater than 65%. The model results highlighted that nitrate leaching was significantly reduced passing from the A scenario to the B and C ones (p<0.01); on average nitrogen losses decreased by up to 53% from A to B and up to 75% from A to C.
|
|
|
|
Palosuo, T. (2013). Data format for model in- and output (Vol. 2).
Abstract: A common format for model input variables and model output variables has been defined to be distributed to modellers participating in the model inter-comparison and improvement. The aim of common formats is to support the communication between the modellers, those providing empirical data of the experiments and those analysing the simulation results. The input format facilitates the model application in a way that each cropping-system to be modelled will be defined in the same way. Data will be delivered in EXCEL sheets with sub-tables for each block of inputs. Tables are mostly organized in a way that allows export and sequential read-in by the models. The common output format enables effective processing of results estimating model performance indicators. No Label
|
|
|
|
Cammarano, D., Rötter, P., Ewert, F., Palosuo, T., Bindi, M., Kersebaum, K. C., et al. (2013). Challenges for Agro-Ecosystem Modelling in Climate Change Risk Assessment for major European Crops and Farming systems. (pp. 555–564).
|
|
